Girair PVC polymer glue, 250 ml can

Girair PVC polymer glue, 250 ml canThis Girair polymer adhesive is a quick drying adhesive and is used with Girair piping systems. Use A brush is supplied with the cold weld polymer adhesive. Cut the pipe to size using a pipe cutter for plastic pipes and bevel the edge. Deburr the ends and mark the insertion depth. Check that the pipe fitting is dry and free of dust and grease. Clean the parts to be bonded with a suitable cleaner and clean cloth. Apply a thin layer of cold weld polymer

This Girair polymer adhesive is a quick-drying adhesive and is used with Girair piping systems.

Use

A brush is supplied with the cold weld polymer adhesive.

• Cut the pipe to size using a pipe cutter for plastic pipes and bevel the edge.
• Deburr the ends and mark the insertion depth.
• Check that the pipe/fitting is dry and free of dust and grease.
• Clean the parts to be bonded with a suitable cleaner and clean cloth.
• Apply a thin layer of cold-weld polymer adhesive to the pipe and fitting up to the insertion depth, slide the fitting straight over the pipe (without twisting) and hold it in place for a few seconds.

After installation and drying time, a pressure test should be performed. The test lasts 12 hours, during which no pressure drop may be observed. The test pressure should be 1.5 times the working pressure, with a maximum of 12.5 bar.

Please note: The Girair system is not suitable for medicinal air, flammable gases, or non-silicon applications.

Do you want to buy a polymer adhesive or need more information?

The desired cold-weld polymer adhesive can be ordered easily and quickly via our website or purchased at one of our branches. Are you not yet sure which polymer adhesive would be best for your situation? Contact one of our product specialists for advice without obligation.