Kia PV5 Cargo L2 | Pro | Rear | Single Drawer

Kia PV5 Cargo L2 | Pro | Rear | Single DrawerImportant: This setup requires a plywood floor please select the correct variant depending on whether your van already has a plywood floor installed or not. The Pro Rear System Single Drawer setup for the Kia PV5 Cargo (L2) is built to unlock the vans full usable load space while keeping tools and materials easy to reach. By raising the floor above the lower wheel arch, the system overcomes the PV5s narrow floor load width to create a full width load

Important: This setup requires a plywood floor — please select the correct variant depending on whether your van already has a plywood floor installed or not.

The Pro – Rear System – Single Drawer setup for the Kia PV5 Cargo (L2) is built to unlock the van’s full usable load space while keeping tools and materials easy to reach.

By raising the floor above the lower wheel arch, the system overcomes the PV5’s narrow floor load width to create a full-width load platform. Both sides of the new floor - where it extends over the lower wheel arch - are fully supported for maximum strength and stability.

As a drawer-based alternative to traditional van racking it gives you quick access to your gear while keeping the side door area clear for bulkier items. It's fully removable, installs in minutes using factory anchor points, and leaves your van untouched.

Constructed from 15mm phenolic-coated plywood, it’s tough, water-resistant, and easy to clean. All drawers run on 220kg-rated locking slides, delivering smooth, dependable access even under load.