SKU: 88507588406

Stator/Voltage Regulator & High Output Flywheel for Polaris XP, Pro XP, XP Turbo, Ranger, 900, General

$332.95 $369.94
Save 10%
No.2 Bestseller on watersyst.com >

Pay in installments of $92.48 with ShopPay, AfterPay and Klarna

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Aug 18 - Aug 23

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

Stator/Voltage Regulator & High Output Flywheel for Polaris XP, Pro XP, XP Turbo, Ranger, 900, GeneralSPLYT Supercharged Technology Stator Voltage Regulator & High Output Flywheel This charging upgrade provides a tremendous 900W output to allow you to install accessories without draining the original battery nor installing a secondary battery. This upgrade installs seamlessly freeing the space a second battery would take on your ride. Use for Polaris machines listed below (see fitment) that need more power to the electrical system. Most of those

SPLYT Supercharged Technology Stator/Voltage Regulator & High Output Flywheel 

This charging upgrade provides a tremendous 900W output to allow you to install accessories without draining the original battery nor installing a secondary battery. This upgrade installs seamlessly freeing the space a second battery would take on your ride.

Use for Polaris machines listed below (see fitment) that need more power to the electrical system. Most of those Polaris machines have 650W stators. Newer Pro XP and Turbo R machines have 800w stators. Each 13w of stator output is about 1 amp more power available. W=IxE

 Details


RMSTATOR SPLYT Technology provides a reliable solution to well-known charging system failures. Using a dual output stator with two completely separate stator windings, this system splits the power generated by the stator into two separate voltage regulators. These regulators then each operate with only half of the load of the original system, allowing them to maintain a lower temperature and increase reliability. 

Ultimate reliability
With a stock charging system, voltage regulators are consistently operating within 5% of their maximum capacity, leading to heat and stress related failure. With the RMSTATOR SPLYT system, both SERIES voltage regulators are operating with 40% overhead for long life and stable output.

Better design
Contrary to the original OEM stator that uses one three phase stator winding, the SPLYT stator contains two completely separate three-phase coil windings. Each of these two windings then produces half of the power of the stock stator lowering the temperature in each individual coil.

Easy to install
All parts use a Plug-and-Play design, just like the original OEM ones, so no special tool or knowledge is needed to install this system.

Harnesses included
Relocation wiring harnesses allow to relocate the regulators anywhere on your vehicle to get better air flow and easier access.

This kit includes:

  • Dual output stator
  • Two SERIES voltage regulators
  • Improved high output flywheel
  • Two automotive grade relocation wiring harnesses with OEM-quality heavy-duty connectors
  • Flywheel puller
  • Gasket
  • Complete instructions for voltage regulator relocation

Solve your Polaris RZR & Sportsman charging system issues today, once and for all, with RMSTATOR!

Note:

  • This kit includes two wiring harness according to Polaris recall # Z-16-01-C (OEM # 2206620, 2206367,2206473). We strongly suggest you to relocate both of your regulators to make sure they do not wear out prematurely due to mud, dust or rocks.


Included Items:

(1) Dual output stator W/(1) 3-pin male connector, (3) male spade terminals & (3) orange rubber connector seals

(2) SERIES voltage regulators W/(4) 3-pin female spade terminals, (10) female spade terminals & (12) rubber connectors seals

(1) High output flywheel

(2) Relocation wiring harnesses with OEM-quality heavy-duty connectors

(1)Flywheel puller

(1) Stator cover gasket

 

Detailed Specifications

Stator Wire to wire resistance :
Alternator: Yellow/Black to Yellow/Black = 0.5 ohms +-20%

Minimum Charging Voltage: 14.5 V +- 0.5 V
Maximum Charging Current: 50 A / 500 W (for each winding separately)
Open Circuit Voltage: < 15 V
Operation Temperature: -20º to 85º Celsius

Fitment

 

Installation Instructions Click here

 

CB 4/3/25

10/20/25 MS

Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 88507588406

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.8 ★★★★★
Based on 12 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
D
Verified Purchase
Della
New York, US
★★★★★ 1
Poorly made product
Size: 7.1 Surround + HDMI
All of the tightening barrels for the bare wire install strip out when I tried to tighten down on the wire. Not just one or two but all 14 connectors failed. Very poorly made.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 11, 2024
A
Verified Purchase
Amazon Customer
Port Orchard, US
★★★★★ 4
Its just ok
Size: 7.1 Surround + HDMI
It looks cheap and feels cheap
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 12, 2025
J
Verified Purchase
James
Cuba, US
★★★★★ 5
Great Banana Plugs
Size: 6 Pairs / 12 pcs
I recently purchased these FosPower banana plugs to tidy up my speaker wiring, and they’ve been a significant improvement over bare wire ends. Installation is straightforward: strip the wire, loosen the two tiny set screws, slide the wire in, tighten everything down, and then screw the barrel back on. Once assembled, the connection feels secure and tight, making it much easier to swap gear around and reducing the risk of stray strands causing a short. The standout feature of this design is the dual set-screw clamp. It firmly grips the speaker wire without relying on the outer collar to “crush” it in place. I’m using 12-gauge wire, and it holds well for my setup. Initially, the plugs may fit snugly in some binding posts. Once seated, there’s no wobble, but it might take a bit of extra push the first time. The set screws are small, so a bit of precision is needed. Use a small flathead screwdriver and don’t over-tighten them. Overall, these plugs feel well-made, look clean once installed, and fulfill their purpose as banana plugs: making speaker connections quick, neat, and reliable.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 27, 2026
T
Verified Purchase
Todd C Blake
Cuba, US
★★★★★ 5
Great Banana Plugs!
Size: 6 Pairs / 12 pcs
These FosPower banana plugs work very well. I have used dozens of these great FosPower banana plugs over the years, and they definitely work as advertised. When comparing apples to apples (or bananas in this case....lol), all Banana plugs work virtually the same way, and these banana plugs are no different. Strip speaker wire, unscrew banana plug cover, loosen speaker wire retaining screw(s), insert speaker wire, tighten speaker wire retaining screw(s), screw on banana plug cover, and wallah, a secure/conductive speaker/amplifier wire connector is created. Albeit, some banana plugs require the speaker wire to be splayed over a hollow post, and then they are held down by a screw-on retainer/cover. However, I much prefer these FosPower dual retaining screw type of banana plugs for their speaker wire holding ability. I always use high quality 14 gauge OFC speaker wire with these FosPower banana plugs, and they work perfectly together. I have used these FosPower banana plugs with many different speaker and amplifier brands over the years, including Klipsch, Pioneer, Polk, Denon, Dayton Audio, and Fosi with no problems at all. They just work, and work well. I have never had a FosPower banana plug break, release the speaker wire or short out, in all of the years that I have used them. Yes, these FosPower banana plugs do fit rather tightly into the connectors, at first, on a lot of speaker and amplifier brands/models. However, after the initial "squeeze" the banana plugs will lossen up, and become easier to install and remove. However, they still retain their great holding ability even after the initial squeeze. In order to overcome this initial "tightness," I usually just stick the FosPower banana plugs into a connector of an old portable amplifier, before assembling them, in order to squeeze them before inserting them into their final speaker or amplifier destinations. This is especially useful when working in tight places, where there is not much room to work in order to push the FosPower banana plugs into their tight connections firmly. Overall, I highly recommend these FosPower banana plugs. I am currently using them all over the house and shop for home theater and music listening (and testing projects). Just be aware of the tight fit in some speakers and amplifiers. Also, the 2 very tiny speaker wire retaining screws can be a challenge sometimes. Just use a good standard blade jewelers screwdriver, and be careful not to remove the retaining screws all of the way or over-tighten them. Once these things are mastered, using these FosPower banana plugs becomes second nature. Have fun!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on August 28, 2024
S
Verified Purchase
Steve M Vedder
Waukegan, US
★★★★★ 5
Great Product
Size: 6 Pairs / 12 pcs
These banana plugs have worked perfectly, no matter what gauge I have run in them, they work great. Easy assembly and great quality.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 8, 2026

recommand products

s25 Bauer 940 Goal Mask SR
187.00
Easton MAV Gametime Batting Gloves
22.00
WILSON C200 CATCHERS KIT YOUTH
200.00
Yeti Rambler 18oz Straw Cap Bottle
29.00
UA Clean Up Batting Gloves ('25) SR
26.00