Toyota Pickup Shifter Mounted Cup Holders

Toyota Pickup Shifter Mounted Cup HoldersOur shifter mounted cup holders are the perfect way to add some cup holders to your old Toyota Pickup. Utilizing factory mounting locations make these an easy install! Throughout 3 generations Toyota has used many different transmission combos. As of now we have two models available that cover 3 different style shift boots. So PLEASE confirm your shifter boot before ordering. We have a fitment guide below to help you determine which model you need. If

Our shifter mounted cup holders are the perfect way to add some cup holders to your old Toyota Pickup. Utilizing factory mounting locations make these an easy install! Throughout 3 generations Toyota has used many different transmission combo’s. As of now we have two models available that cover 3 different style shift boots. So PLEASE confirm your shifter boot before ordering. We have a fitment guide below to help you determine which model you need. If you are unsure, please ask. We will be happy to help!

The smaller insert will fit a standard size soda can, while the larger one will fit about anything else. Certain drinks fit a bit awkward in the larger insert due to the step down design. If you have this issue be sure to check out our XL insert.

Practice your 2nd Amendment rights? Be sure to check out our Molle Panel to mount your holster or whatever else you choose! Keep in mind these will be tight, or not work at all if you are using factory SR5 trim around the shifter.

Please note: If you have the trim pieces around your shift boot that are on certain trim packages, you will likely have to notch this to allow the cup holder to clear since we use thick steel on our cup holders. No flimsy junk sold here.

Offered in raw steel or satin black powder coat. Orders will normally ship same week, but please allow 7 business days before contacting regarding the status of your order. Powder coat will add an addition 7 business days

FITMENT GUIDE:

If you notice we have 2 models of cup holders and are wondering which you need? Check the guide below to see which one you need! YOU MUST visually verify, that is the only way to guarantee fitment. This may mean, lifting the carpet to expose the shifter ring. If your boot/trans setup does not look like the ones pictured, it mostly likely will not work. We are not responsible for incorrect orders. Just because it SHOULD fit, does not mean it will. Visual confirmation is the only way.

CUP HOLDER FITMENT GUIDE

These will not fit Tacoma or 3rd Generation 4Runners.

You will lose most of your forward seat travel, which is needed on 4Runners to access rear seat. Check out our dash mounted cup holder if you have a 4Runner.