Radial Engineering PZ-PRO 2-Channel Acoustic Instrument Preamp

Radial Engineering PZ-PRO 2-Channel Acoustic Instrument PreampTake complete control over your tone, EQ settings, and effects with the PZ Pro, a two channel instrument preamp, DI and switcher. Each channel features a separate equalizer strip complete with a filter section to reduce feedback on stage. The second channel of the PZ Pro also features a microphone input to allow any dynamic or condenser microphone to be used, including clip on instrument mics. Three footswitches provide the ability to toggle between

Take complete control over your tone, EQ settings, and effects with the PZ-Pro, a two channel instrument preamp, DI and switcher. Each channel features a separate equalizer strip complete with a filter section to reduce feedback on stage. The second channel of the PZ-Pro also features a microphone input to allow any dynamic or condenser microphone to be used, including clip-on instrument mics. Three footswitches provide the ability to toggle between each input channel, activate a built-in booster and an effects loop, or mute the signal for silent tuning on stage.

Mission control for your acoustic setup
The PZ-Pro is designed for instrumentalists and performers who take a no-compromise approach when it comes to tone, both on stage and in the recording studio. Dual input channels allow you to switch between or blend together two sources, with full control over the sound of each input. Each channel has its own semi-parametric equalizer section and input level, along with individual filter controls to reduce feedback on stage. The second channel of the PZ-Pro also features a microphone input to allow any dynamic or condenser microphone to be used, including clip-on instrument mics or even vocal microphones. An FX Loop with a wet/dry knob provides the ability to blend in as much or as little pedal effects as desired, with a footswitch to bring them in and out of the signal chain at a moment's notice. Finally, once your tone is completely dialed-in, balanced XLR direct outs feed the PA system or a recording interface, with both Pre-EQ and Post-EQ outputs available.

Adaptable for any application
The PZ-Pro is highly configurable, so you can adapt it to meet the needs of your performance, instead of changing your performance to fit the limitations of your gear. Connect magnetic pickups, instruments with on-board preamps, or piezo transducers, and optimize the sound of each with powerful EQ controls and a variable notch or high-pass filter. Blend an instrument mic with your pickups, switch between two instruments, or connect a vocal microphone and feed it through your guitar pedals. The FX loop can be assigned to channel A, B, or both at once, and you can activate it with a footswitch or assign it to be always on, saving footswitch control for the variable clean boost function. With the PZ-Pro, you get the durability and performance Radial is known for, along with all the features you need to put on an unforgettable show.

Features
• Two independent input channels with separate EQs
• Microphone input on channel-B with 48V phantom power
• EFX Loop and clean Boost with footswitch control
• Balanced pre and post-EQ outputs to feed PA/Monitors
• Switch/Combine instruments with a clip-on or vocal mic
• PZ Boost circuit to optimize for use with piezo transducers
• Selectable High-Pass/Notch filter to reduce on-stage feedback
• Reconfigure the EFX/Boost footswitch to suit your setup