Connecting the MXG 1.2 Strada Dash to your ECU (road or race) is very simple. You can sample and display dozens of channels straight from your vehicles ECU. This is often the quickest and easiest setup, needing only two cable connections to the ECU instead of multiple connections to analogue sensors.

The sampled data depends on the actual ECU but typically RPM, throttle position (TPS), oil / air / water temperature, oil pressure, battery voltage, speed, gear, lambda value (air / fuel ratio). The list of ECU drivers is over 1000+ and is constantly being updated and upgraded.

Pre-Configured Pages

The MXG Strada shows together with RPM scale, all the data you need such as speed, water temperature and oil pressure, lap times and much more. You can choose the custom pages you want, including up to four additional fields. We have a large library of page styles, defining which data to be shown and their end of scale and measure units, also swapping between pages is easy using the push buttons.

Flexible Shift Lights & Alarms

The ten multi-coloured RGB shift lights can be customised to your liking, defining the RPM threshold for each single gear. The same flexibility applies to the configurable RGB alarm LEDs: you can configure them in order to turn them on/off depending on analogue or digital inputs, ECU values, expansion values, math channels or - optionally - GPS information. You choose conditions and colours: select a solid alarm or flashing one - and the flashing frequency. It is also possible to configure an accompanying text message, and set the alarm priorities.