RISLONE Power Steering Repair - 2 Part Formula 44650

RISLONE Power Steering Repair - 2 Part Formula 44650Rislone Power Steering Repair is a unique dual cavity bottle containing a combination of the best performance additives to repair the most common power steering fluid related problems. For many vehicles, this is your last chance before paying an expensive repair bill or replacing the vehicle. Power Steering Repair can be used to top off the existing fluid when low, or add a bottle when changing fluid. Works on all vehicles, domestic and import.

• Reduces Noise & Smoothes Out Hard Steering
  
• Stops Leaks and Reconditions Rack & Pinion
• Restores Performance
• Adds Protection

Dosage & Directions

Dosage 
1 bottle treats 2 to 3L of power steering fluid. For larger systems use 1 bottle for every 2.5L of fluid capacity.

Directions
Adding to Power Steering Fluid 

1. Remove power steering dipstick and check reservoir fluid level. On most vehicles, this is on or near the belt driven power steering pump. Consult owners’ manual for location.
   If fluid is low, pour equal amounts from the two chambers into reservoir. At least ½ of bottle should be used. Do not overfill.
2. If necessary to prevent overfilling, drain or siphon some power steering fluid from reservoir. Check fluid level again. Top off with manufacturer’s recommended power steering fluid as needed.
3. Replace dipstick and drive 5 to 10 minutes to circulate fluid.
4. Depending on the power steering problem, results will either be immediate or noticeable within 2 or 150 km of driving. In seriously damaged power steering systems, a second treatment may be required. In this case, it is suggested that the power steering fluid be changed and a second application of Power Steering Repair be added.

Changing Fluid
If using Power Steering Repair when changing power steering fluid, add entire contents of bottle. Then top off with manufacture’s recommended fluid to proper level. Drive vehicle and recheck fluid level.

Frequently Asked Questions

Will Rislone Power Steering Repair work in my vehicle?
Yes, Rislone Power Steering Repair is compatible with all petroleum based, mineral oil, synthetic and ATF power steering fluids. This includes all domestic, import and heavy duty power steering applications.

How long does it take to start working?
Depending on the power steering problem, results will either be immediate or noticeable within a few days of driving.

If first application does not completely stop the leak, may I add another bottle?
Yes, you can install a second application for hard to stop leaks. We recommend that the power steering fluid be changed and a second application of Rislone Power Steering Repair be added.

How much do I install?
The 500 mL bottle of Rislone Power Steering Repair, part number 44650, is designed for one bottle to be used for every 1 to 2.5 litres of fluid capacity, which is the normal size for most vehicles. On smaller systems from 0.4 to 0.9 litres, only use half bottle, pouring equal amounts from each side. For larger systems use one bottle for every 2 litres of capacity.

What are the symptoms of a power steering leak?
Depending on the severity of the leak, the first thing you may notice is spotting, where you will find fluid spots located on the driveway or garage floor. While looking under the vehicle around the area where the rack & pinion or gearbox is located; or the front of the engine where the belt is located, you will find fluid dripping. The next thing that happens is the steering wheel becomes harder to turn or does not turn smoothly. This is usually accompanied by a squealing or grinding noise when turning the wheel.

How does Rislone Power Steering Repair stop leaks?
This product works in two ways to help solve most any o-ring or seal leaks.

The seal restorer additive restores seal size, flexibility and elasticity lost due to heat, age and high mileage.

The seal polymer works by building a polymeric film around the seal or o-ring and also filling in any grooves worn in the shaft.

What causes power steering leaks?
The most common cause of power steering system leaks is age and/or high kilometre. After time, power steering seals and o-rings tend to dry out and shrink causing leaks. Rislone Power Steering Repair works to revitalize these seals and makes them soft and pliable again.

I have fluid collecting in the rubber bellows at either end of my steering rack, is this normal?
No, the rubber bellows are mainly designed to keep dirt out of the steering rack and only keep in a small amount of thick grease which lubricates the inner tie rod ends. Any signs of fluid in or leaking from the bellows means a seal inside the rack is leaking. Rislone Power Steering Repair is the perfect product to use for this type of leak.

Will I damage my system if I drive without fluid in my power steering?
Yes, usually damage to your power steering pump will happen within relatively few kilometres if you continue to drive with little or no fluid in your power steering reservoir.

Will Rislone Power Steering Repair help my noisy power steering pump?
Yes, Rislone Power Steering Repair contains special friction modifiers to stop bearing, piston and valve noises inside the pump.

Will I have steering if the power steering fails?
Yes, you will always have steering, but the vehicle will be very difficult to steer.

The mechanic said my car has morning sickness. What is this?
Morning sickness is a condition where the vehicle will be hard to steer in the mornings or when cold. In many cases it will feel as if the power steering is not working at all. The cause of this problem is fluid bypassing worn o-ring seals in the sector shaft (where the shaft from the steering wheel connects to the rack & pinion) or grooves actually worn into the rack. After driving the vehicle and warming the fluid, the problem will usually go away, until the next day. Adding Rislone Power Steering Repair will renew these o-rings and the polymer additives will prevent the fluid from bypassing the grooves.

Will Rislone Power Steering Repair help smooth my rough steering?
Yes, special lubricity additives will smooth out rough, hard and tight steering.

Will Rislone Power Steering Repair harm my steering system?
No, the product is completely safe to use and will not harm any part of the power steering system.

My reservoir is not very low, can I just top of the system with Rislone Power Steering Repair?
If you have a very minor leak, you may not be able to add the entire bottle. The product works great for topping off the power steering fluid level any time you need to add fluid. If using for other problems, you need to add at least ½ of the bottle into the system.

What is a power steering system?
There are two basic types of Power Steering Systems:

Gearbox (Re-circulating-Ball)
Most Rear-Wheel & 4-Wheel Drive. The gearbox contains a grooved metal shaft called a worm gear. This gear is threaded into a metal block with ball bearings between the threads to reduce friction. The block turns a pitman arm which is connected by the tie rods to each front wheel.

Rack & Pinion
Most Front-Wheel & All-Wheel Drive. The steering shaft connects to a pinion gear inside the metal housing. This pinion gear has teeth on it that mesh with the teeth on the rack. This rack is connected to each front wheel with the tie rod ends.

Steering Components - Power steering systems are combination of mechanical, hydraulic and some electrical parts.

Mechanical
Many mechanical parts are required to operate a power steering system. Some of the more important parts are steering shaft, rack & pinion or gearbox and fluid pump.

Hydraulic
The hydraulic system uses a belt-driven fluid pump to create pressure and send this fluid through a high pressure hose to either the rack & pinion or gearbox.

Electrical
Some later model vehicles use electronic sensors to detect the power steering fluid pressure and send information to the vehicle computer.

The common element between all of the power steering components is the fluid. The fluid touches everything inside the pump, gearbox and rack & pinion. This fluid must lubricate, cool, clean and pressurize for the system to function. In newer systems, the power steering fluid can easily perform these functions. As the vehicle ages and gains more kilometres, the fluid alone can’t do the job. Internally, pumps whine, gears have play in them, valves stick, seals leak and the fluid quickly breaks down. When installed, Rislone Power Steering Repair helps to stop and prevent these problems and enhances the useful life of your power steering system.

Technical Information

SAFETY DATA SHEET
CODE: 44650
SIZE: 500ML