30-Amp Pro Switch-Mode BEC Bru

30-Amp Pro Switch-Mode BEC BruUp to 30 amps continuous current with proper air flow and 35 amps burst current (15 seconds) 3. 5A continuous current, 5V Switch Mode BEC Circuit Stronger BEC for support of most 3 axis stabilization systems Drive up to 7 analog or 6 digital standard size servos with the BEC 3 to 4 cell Li Po, 9 to 12 cell Ni MH Ni Cd input voltage Programmable motor braking Safe power arm mode prevents accidental starts Programmable low voltage cutoff with settings

Up to 30 amps continuous current with proper air flow and 35 amps burst current (15 seconds) 3.5A continuous current, 5V Switch-Mode BEC Circuit Stronger BEC for support of most 3-axis stabilization systems Drive up to 7 analog or 6 digital standard-size servos with the BEC 3- to 4-cell Li-Po, 9- to 12-cell Ni-MH/Ni-Cd input voltage Programmable motor braking Safe power-arm mode prevents accidental starts Programmable low voltage cutoff with settings for 3-cell Li-Po (9.2V), 4-cell Li-Po (12V) or 74% of battery starting voltage Programmable throttle input range (1.1ms–1.9ms or 1.2ms–1.8ms) Programmable soft start for helis and airplanes Auto motor shut down if signal is lost or there is interference Programmable timing—5 user-selectable ranges for use with a large variety of brushless motors Pre-wired connectors—E-flite EC3™ connector on battery input and 3.5mm gold bullet connectors on motor output leads Overview Back to Top ^ The E-flite® 30-Amp Pro Switch-mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication. Specifications Back to Top ^ Continuous Maximum Current: 30A (proper cooling required) Input Voltage: 3–6S Li-Po or 9–18 Ni-MH/Ni-Cd Input Connector Types: 16 AWG leads with E-flite EC3 Connector Output Connector Types: 16 AWG leads with 3.5mm Gold Bullet Connectors Momentary Peak Current: 35A (15 sec) Length: 51.0mm (2.00 in) Width: 28.0mm (1.10 in) Height: 8.70mm (0.35 in) Weight: 31.0 g (1.10 oz) Wire Gauge: 16 AWG