Pay in installments of $53.74 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Aug 12 - Aug 17
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Resistor HTD Gauntlet GlovesKLIM SIZING CHART Take your cold weather adventures to new lows with the Resistor HTD Gauntlet Glove and its intuitive 3 level heating system. The heating filaments are durable while long lasting lithium ion batteries ensure consistent heating for your hands and fingers. The high heat mode runs for 10 minutes and automatically switches to medium heat to preserve batteries and avoid overheating your hands. The heating element covers your backhand and
Take your cold weather adventures to new “lows” with the Resistor HTD Gauntlet Glove and it’s intuitive 3-level heating system. The heating filaments are durable while long lasting lithium-ion batteries ensure consistent heating for your hands and fingers. The high heat mode runs for 10 minutes and automatically switches to medium heat to preserve batteries and avoid overheating your hands. The heating element covers your backhand and fingertips, providing full hand heat when used with heated grips on a snowmobile.
GLOVES
- GORE-TEX
- GUARANTEED TO KEEP YOU DRY
- 3M™ THINSULATE™ INSULATION - 200G BACKHAND, 100G PALM
- 3M™ SCOTCHLITE™ REFLECTIVE MATERIAL
- LEATHER PALM AND FINGERS
- KNUCKLE PROTECTION
- COMFORT FLEECE BACKHAND FOR ADDED WARMTH
- SHOCK CORD ADJUSTMENT
- VELCRO WRIST CLOSURE
- GOGGLE SQUEEGEE
- RIDER GRIP ARTICULATION
- ENTRY ASSIST PULL LOOP
- MOISTURE WICKING LINER
- PLASTIC CLIP CONNECT
HEAT SYSTEM
- HEAT ELEMENTS WRAP FINGERTIPS AND BACKHAND
- UP TO 8 HOURS ON LOW HEAT (GREEN LIGHT)
- UP TO 3 HOURS ON MEDIUM HEAT (BLUE LIGHT)
- UP TO 1.5 HOURS ON HIGH HEAT (RED LIGHT)
- 10-MIN HIGH HEAT AUTO TIMER REVERTS TO MED HEAT (CAN BE OVERRIDDEN BACK TO HIGH HEAT)
- RED-BLUE-GREEN HEAT LEVEL LIGHTING CODE
- LITHIUM-POLYMER BATTERY (1 PER GLOVE)
- ZIPPERED BATTERY COMPARTMENT
- REPLACEMENT BATTERIES AVAILABLE
INSTRUCTIONS
How to use
1. Make sure your Resistor HTD Gauntlet Glove is fully charged. (24hrs recommended for 1st charge. For full charging information visit KLIM.com/manuals)
2. To turn on, press and hold button for 3 seconds until red light turns on
3. Short press to change heat level
a. HIGH Heat – RED Light
Note: HIGH Heat runs for 10 minutes at a time to prevent excessive heating. After 10 minutes glove automatically switches to MEDIUM Heat to preserve temperature. HIGH Heat can be reactivated by pressing the button until the indicator light turns Red.
b. MEDIUM Heat – BLUE Light
c. LOW Heat – GREEN Light
4. To turn off, press and hold the button for 3 seconds until the light turns off
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.8 ★★★★★
Based on 6 reviews
Sort
Product Reviews
★★★★★ 5
It Works!!!!!
Size: Powder Poli Ox - Pack of 6
We have only completed the first two steps it Poly Glo set we purchased and has it ever made a difference in the look of our hauler/trailer! The dull oxidize black color is somewhat shiny. Cant wait to put the final two steps on it! A little elbow grease and work did wonders! We will share a photo once the procedure is complete!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 19, 2026
★★★★★ 4
Could be good
Size: Powder Poli Ox - Pack of 6
I cleaned my RV very thorough from top to bottom before even starting the process with the Poli Glow system. Here's what I learned despite videos and lots of reading reviews.
1. Must be very clean and clear of anything you dont want to stick and show on your final outcome.
2. It takes more coats than you think it would (after 3 coats) it was still really streaky and I was starting to regret using Poli Glow. I ended around 7-8 coats and my rig had no major oxidation at all.
3. As one reviewer said, use a clean microfiber cloth v the applicator that comes with it, I found much better results with no lines.
4. Dont go to heavy on the coating, the instructions say this, but I went super light and it can be very easy to get lines with heavier application.
5. Dont look at your work after 3 coats, you will feel deflated, just keep going for at least 6 coats and then look at your work.
6. Only do small areas and look out for drips and lines, you need to get them out right away.
7. I did not use the Poli Ox, I was able to get any oxidation out with just the Poli Prep
8. Going up and down a ladder for hours sucks!
9. I hope it will come off in the next couple of years when I plan to replace the decals. Honestly, thats my biggest fear is how hard it will be to remove when the time comes.
10. After a scary start, I will say it did turn out pretty nice, was it easy, nope, would I do it again? Not sure, I need some time for my back to heal up!
If you do choose Poli Glow know there are other options that maybe a better way to go such as wet sanding etc. Poli Glow is pretty good, but it can be pretty bad also if the surface is not cleaned and the Poli Glow applied correctly.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on August 17, 2023
★★★★★ 5
Poli glow works!
Size: Powder Poli Ox - Pack of 6, Size: Powder Poli Ox - Pack of 6
Works amazing! After many attempts to buff I purchased Poli glow and done in less than half the time and beautiful result.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 19, 2026
★★★★★ 5
Wonderful product
Size: Powder Poli Ox - Pack of 6
This product has exceeded our expectations.
Thank you
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 20, 2026
★★★★★ 3
Good but DO NOT USE APPLICATOR MITT
Size: Powder Poli Ox - Pack of 6, Size: Powder Poli Ox - Pack of 6
The poli-ox worked well, just know that it will require several applications to remove old buildup and oxidation. once you are done, the paint will still look oxidized, but once you put the sealer on, the color will be deep and shiny.
The sealer itself is supposed to be enough for a much bigger RV than we used it for. (17') We used 3/4 of a bottle for 1 side, due to the fact that we would remove and start over because it left ridges like a brush in paint. On the second side of the RV, we scrapped using the Mitt, and low and behold, using a microfiber towel to apply solved all of the issues. No more ridges and the remaining 1/4 of the bottle was enough to apply 5 coats. The mitt also wastes a LOT of product. So be warned use a Microfiber towel (that has been previously washed) and it will save you a LOT of time, money and angst.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 12, 2023
recommand products
Berkeley B76761KIT - B3ZPBHS 8.813C 1.25X12.5 W/O MTR FLGD SI
1883.76
Berkeley B78723 - B8GQBM 1-1/2-10T SAE4 12.125F
4987.26
Berkeley B75178NP - B2ERHHS CW 10.44" FULL
2230.47
Berkeley B75254EF2 - B1-1/2ZPHS 3HP 1800/60/3 TEFC SIL.BR
1314.84
Berkeley B75002 - B4JQBH 1-3/8-10 3EXT SAE 3 13.5F SIL BRZ
4546.68