Insulation characteristics

• Insulation : Safe isolation: Control side / contact side

Insulation characteristics

• Insulation : Safe isolation: Control side / contact side
• Overvoltage category : III
• Pollution degree : 3

Electrical properties

• Maximum power dissipation for nominal condition : 0.43 W
• Test voltage (Winding/contact) : 4 kV AC (50 Hz, 1 min., winding/contact)
• Test voltage (Changeover contact/changeover contact) : 2.5 kV AC (50 Hz, 1 min., changeover contact/changeover contact)
• Rated surge voltage : 6 kV

Input data

Coil side

• Nominal input voltage UN : 24 V DC
• Input voltage range : 20.2 V DC ... 33.6 V DC (20 °C)
• Drive and function : monostable
• Drive (polarity) : polarized
• Typical input current at UN : 18 mA
• Typical response time : 8 ms
• Typical release time : 10 ms
• Protective circuit
  • Reverse polarity protection; Polarity protection diode
  • Freewheeling diode; Freewheeling diode
• Operating voltage display : Yellow LED

Output data

Switching

• Contact switching type : 2 changeover contacts
• Type of switch contact : Single contact
• Contact material : AgNi
• Maximum switching voltage : 250 V AC/DC (The separating plate PLC-ATP should be installed
  for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules. Potential bridging is then carried out with FBST 8-PLC... or ...FBST 500...)
• Minimum switching voltage : 5 V AC/DC (10 mA)
• Limiting continuous current : 6 A
• Maximum inrush current : 15 A (300 ms)
• Min. switching current : 10 mA (5 V)

1. Datasheet - PHOENIX 2967060